Selecting language

To select the language, perform the following procedure.

1. Select the “SETUP” menu.

2. Select the “SYSTEM SETUP” menu.

3. Select “SEL LANGUAGE” by operating the “TUNE/TRACK/CH” dial.

4. Select the desired language by operating the “TUNE/TRACK/CH” dial.

    See also:

    To change mode of driver’s control center differential
    Press the “AUTO-MANU” switch on the center console to switch from auto mode to manual mode or vice versa. When you select the auto mode, the “AUTO” indicator light illuminates. When you select the m ...

    Starting the engine
    Do not operate the starter motor continuously for more than 10 seconds. If the engine fails to start after operating the starter for 5 to 10 seconds, wait for 10 seconds or more before trying aga ...

    Compass zone adjustment
    Compass calibration zones 1. The zone setting is factory preset to Zone 8. Refer to the “Compass calibration zones” map shown above to verify that the compass zone setting is correct for your geograp ...