Initializing the registered data

To initialize the registered data, perform the following procedure.

1. Select the “SETUP” menu.

2. Select the “SYSTEM SETUP” menu.

3. Select “INITIALIZE” by operating the “TUNE/TRACK/CH” dial.

4. Select “CONFIRM” by operating the “TUNE/TRACK/CH” dial. First “PLEASE WAIT”, then “INITIALIZED” is displayed.

The registered data is initialized and the mode changes to the last mode.

    See also:

    Cooling system
    Never attempt to remove the radiator cap until the engine has been shut off and has cooled down completely. Since the coolant is under pressure, you may suffer serious burns from a spray ...

    Active head restraint
    The front seats of your vehicle are equipped with active head restraints. They automatically tilt forward slightly in the event the vehicle is struck from the rear, decreasing the amount of ...

    Light control switch
    The light control switch only operates when the key is inserted into the ignition switch. Regardless of the position of the light control switch, the illuminated lights are turned off when the ke ...