List phones function
The cell phone voice tags saved in the cell phone list are spoken by using the list phones function.
1. Select the “SETUP” menu.
2. Select the “PHONE SETUP” menu.
3. Select the “LIST PHONES” menu. If no cell phones are registered, “EMPTY” is displayed and the mode changes to the “PHONE SETUP” mode.
4. Registered cell phones are displayed on the saved side. While displayed, if the “TUNE/TRACK/CH” dial is turned, the next registered cell phone is displayed.
Press the ON hook button 
to close
the Hands-free menu.
5. Select a cell phone by operating the “TUNE/TRACK/CH” dial or pressing the talk switch 
. Then “SELECTED” is displayed.
6. Select the following menus.
• “SELECT PHONE” to connect the selected cell phone
• “CHANGE NAME” to change the voice tag
• “DELETE” to delete the selected cell phone from the list
• “GO BACK” to go back to the “PHONE SETUP” mode
See also:
Pre-heating or pre-cooling the interior of the
vehicle
Before exiting the vehicle, set the temperature
controls to the desired setting
and operation. After the system starts the
vehicle, the heater or air-conditioning will
activate and heat or coo ...
Temperature gauge (models with type A combination
meter)
1) Normal operating range
The temperature gauge shows engine
coolant temperature when the ignition
switch is in the “ON” position.
The coolant temperature will vary in
accordance with the ...
To arm the system using remote transmitter
1. Close all windows and the moonroof (if equipped).
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood (and the trunk lid ( ...