Deleting device

1. Select the “DELETE AUDIO” menu by operating the “TUNE/TRACK/CH” dial. If no devices are registered, “EMPTY” is displayed and the mode changes to the Bluetooth® audio setting mode.

2. Select the “CONFIRM” menu by operating the “TUNE/TRACK/CH” dial. “DELETED” is displayed and the mode changes to the Bluetooth® audio setting mode.

    See also:

    Headlight flasher
    CAUTION Do not hold the lever in the flashing position for more than just a few seconds. To flash the headlights, pull the lever toward you and then release it. The high beam will stay on for as ...

    High beam light bulbs
    Right-hand side 1. Use a screwdriver to undo the clips on the air intake duct, then remove the air intake duct (right-hand side). 2. Disconnect the electrical connector from the bulb. 3 ...

    Low tire pressure warning light (U.S.-spec. models)
    When the ignition switch is turned to the “ON” position, the low tire pressure warning light will illuminate for approximately 2 seconds to check that the tire pressure monitoring system ( ...