When “CHECK DEVICE” is displayed
This message is displayed under the following conditions.
• When there is a short in the USB bus
• When a non-corresponding device (for example a USB mouse) is connected
• When a non-corresponding iPod® is connected
• When a connected iPod® is frozen
• When a transmission malfunction occurs
• When an iPod® confirmation malfunction occurs
• When a HUB class USB storage device is connected
Disconnect the USB storage device/iPod® and check it.
See also:
Canceling the function for meter/gauge needle movement upon turning on the
ignition switch
Type A
Type B
It is possible to activate or deactivate the
movement of the meter needles and
gauge needles that takes place when the
ignition switch is turned to the “ON”
position.
1. T ...
Under-floor storage compartment (if equipped)
Under-floor storage compartment (if equipped)
The storage compartment is located under
the floor of the cargo area, and it can be
used to store small items. To open the lid,
pull the tab up ...
Compass calibration
1. If a “C” is displayed in the compass window, the compass needs to be calibrated.
2. Drive the vehicle in a circle at 5 mph (8 km/h) or less until the display reads
a direction.
3. You can also ...
