If the light is blinking

If the light is blinking while driving, an engine misfire condition has been detected which may damage the emission control system.

To prevent serious damage to the emission control system, you should do the following.

• Reduce vehicle speed.

• Avoid hard acceleration.

• Avoid steep uphill grades.

• Reduce the amount of cargo, if possible.

The CHECK ENGINE warning light may stop blinking and illuminate steadily after several driving trips. You should have your vehicle checked by an authorized SUBARU dealer immediately.

    See also:

    Compass zone adjustment
    Compass calibration zones 1. Refer to the “Compass calibration zones” map shown above to verify that the compass zone setting is correct for your geographical location. 2. Press and hold the swi ...

    Manual tuning
    Type A and B audio Type C audio Turn the “TUNE/TRACK/CH” dial clockwise to increase the tuning frequency and turn the “TUNE/TRACK/CH” dial counterclockwise to decrease it. Each time the dial is tur ...

    To decrease the speed (by the “RES/SET” switch)
    Press the “RES/SET” switch to the “SET” side and hold it until the vehicle reaches the desired speed. Then, release the switch. The vehicle speed at that moment will be memorized and treated as ...