Initialization of power window (type A)

Subaru Impreza / Subaru Impreza Owners Manual / Keys and doors / Windows / Power windows / Initialization of power window (type A)

If the vehicle’s battery is disconnected due to situations such as battery or fuse replacement, the following functions are deactivated.

• One-touch auto up/down function
• Anti-entrapment function

Initialize the power window using the following procedure to reactivate these functions.

1. Close the driver’s door.

2. Turn the ignition switch to the “ON” position.

3. Open the driver’s side window halfway by pushing down the power window switch.

4. Pull up the power window switch and close the window completely. Continue pulling up the switch for approximately 1 second after the window is closed completely.

    See also:

    Tongue load
    Tongue load WARNING If the trailer is loaded with more weight in the back of trailer’s axle than in the front, the load is taken off the rear axle of the towing vehicle. This may cause the rea ...

    Defrosting or defogging the windshield
    To direct warm air to the windshield and front door windows: 1. Set the air inlet selection button to the OFF position. 2. Press the “” button. 3. Turn the temperature control dial all the way to t ...

    Rear ashtray (STI – if equipped)
    Rear ashtray (STI – if equipped) The rear ashtray is located on the upper side of the back of the center console. To open the ashtray, pull the upper edge of the lid. Fully close the lid after using ...