If you have accidentally triggered the alarm system
To stop the alarm
Do any of the following operations:
• Press any button on the remote transmitter.
• Turn the ignition switch to the “ON” position.
NOTE
Only registered keys will stop the alarm. If the immobilizer transponder is not registered, the alarm will not stop.
See also:
Floor mat
Floor mat
Retaining pins are located on the driver’s
side floor.
The floor mat is secured using the built-in
grommets, by placing the grommets over
the pins and pushing them downward.
...
Trunk light
1. Remove the cover by squeezing its sides and pulling it.
2. Pull the bulb out of the socket.
3. Install a new bulb.
4. Reinstall the cover. ...
Tire pressure monitoring system (TPMS) (if equipped)
The tire pressure monitoring system provides the driver with a warning message
by sending a signal from a sensor that is installed in each wheel when tire pressure
is severely low.
The tire pre ...