When you do not tow a trailer

- Remove the ball mount from the hitch receiver tube and insert the receiver cover onto the hitch receiver tube.

- Place the dust cap over the four-pin connector of the hitch wire harness to protect against possible damage.

- Occasionally lubricate terminals of the four-pin connector using terminal grease.

    See also:

    Unlocking the rear gate
    Unlocking the rear gate Pressing the “” button unlocks the rear gate. An electronic chirp will sound twice and the turn signal lights will flash twice. ...

    Engine low oil level warning light
    The engine low oil level warning light illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 2 seconds. This light also illuminates when the engine ...

    Ride, Handling & Braking
    Employing a car-based four-wheel-independent suspension since its mid-1990s inception, the Outback displays admirable ride quality. It soaks up bumps with little driver disturbance but maintains g ...