Initializing the registered data

To initialize the registered data, perform the following procedure.

1. Select the “INITIALIZE” menu.

2. Select the “CONFIRM” menu. First “PLEASE WAIT”, then “INITIALIZED” is displayed. The registered data is initialized and the mode changes to the last mode.

    See also:

    Head restraint adjustment
    Both the rear window side seats and the rear center seat are equipped with head restraints. WARNING ● Never drive the vehicle with the head restraints removed because they are designed to ...

    Map light
    1. Remove the lens by prying the edge of the lens with a flat-head screwdriver. 2. Turn the bulb until the flat surfaces at its ends are aligned vertically. Pull the bulb straight downward to r ...

    Immobilizer system
    This light blinks approximately 60 seconds after the ignition switch is turned from “ON” position to the “Acc” or “LOCK” position or immediately after the key is pulled out. Refer to “Immobilizer” ...