List phones function

The cell phone voice tags saved in the cell phone list are spoken by using the list phones function.

1. Select the “LIST PHONES” menu. If no cell phones are registered, “EMPTY” is displayed and the mode changes to the “PHONE SETUP” mode.

2. Registered cell phones are displayed on the saved side. While displayed, if the “TUNE/TRACK/CH” dial is turned, the next registered cell phone is displayed.

Press the ON hook button the to close the Hands-free menu.

3. Select a cell phone by operating the “TUNE/TRACK/CH” dial or pressing the talk switch displayed.. Then “SELECTED” is displayed.

4. Select the following menus.

- “SELECT PHONE” to connect the selected cell phone
- “CHANGE NAME” to change the voice tag
- “DELETE” to delete the selected cell phone from the list
- “GO BACK” to go back to the “PHONE SETUP” mode

    See also:

    Type B audio set (if equipped)
    The audio set will operate only when the ignition switch is in the “Acc” or “ON” position. ● Power and sound controls: refer to page 5-6 ● Radio operation: refer to page 5-9 ● ...

    Immobilizer system
    This light blinks approximately 60 seconds after the ignition switch is turned from “ON” position to the “Acc” or “LOCK” position or immediately after the key is pulled out. Refer to “Immobilizer” ...

    Checking the fluid level
    1) “MAX” level mark 2) “MIN” level mark Check the fluid level monthly. Check the fluid level on the outside of the reservoir. If the level is below “MIN”, add the recommended brake fluid to “MAX” ...