Registering by inputting manually

1. Select the “MANUAL INPUT” menu by operating the “TUNE/TRACK/CH” dial.

2. Input the phone number to be registered.

3. Select the “RECORD NAME” menu by operating the “TUNE/TRACK/CH” dial or press the talk switch 4. Say the name (voice tag) to be.

4. Say the name (voice tag) to be registered.

5. Select the “CONFIRM” menu. Then “STORED” is displayed and the mode changes to the registering speed dial mode. Refer to “Registering speed dial”.

NOTE
While inputting the phone numbers, if “GO BACK” (type C audio)/“BS” (type D audio) is chosen using the “TUNE/ TRACK/CH” dial, the character that was input last is deleted.

    See also:

    When you do not tow a trailer
    ● Remove the ball mount from the hitch receiver tube and insert the receiver cover onto the hitch receiver tube. ● Place the dust cap over the four-pin connector of the hitch wire harne ...

    Remote transmitter program
    New transmitters can be programmed to the remote engine start system in the event that a transmitter is lost, stolen, damaged or additional transmitters are desired (the system will accept up to e ...

    Vehicle load limit – how to determine
    The load capacity of your vehicle is determined by weight, not by available cargo space. The load limit of your vehicle is shown on the vehicle placard attached to the driver’s side B-pillar. Loca ...