Rear wiper
To turn the rear wiper on, turn the knob on the end of the wiper control lever upward to the “INT” or “ON” position.
To turn the wiper off, return the knob on the end of the lever to the “OFF” position.
With the switch turned to the “INT” position, the rear wiper will operate intermittently at intervals corresponding to the vehicle speed (longer when the vehicle speed is low; shorter when the vehicle speed is high).
When the transmission is shifted into reverse, the rear wiper will switch to continuous operation. When the transmission is shifted to a position other than reverse, the rear wiper will return to intermittent operation.
See also:
Vehicle Dynamics Control operation indicator light
The indicator light flashes during activation
of the skid suppression function and
during activation of the traction control
function.
NOTE
- The light may remain illuminated for
a short pe ...
Checking the oil level
1) Yellow handle
1. Park the vehicle on a level surface and stop the engine.
2. Pull out the level gauge, wipe it clean, and insert it again.
1) Upper level
2) Lower level
3. Pull out the lev ...
Checking the coolant level
Checking the coolant level
1) “FULL” level mark
2) “LOW” level mark
Check the coolant level at each fuel stop.
1. Check the coolant level on the outside
of the reservoir while the engine is c ...