SRS airbag system warning light
If the warning light exhibits any of the following conditions, there may be a malfunction in the seatbelt pretensioners and/or SRS airbag system. Immediately take your vehicle to your nearest SUBARU dealer to have the system checked. Unless checked and properly repaired, the seatbelt pretensioners and/or SRS airbag will not operate properly in the event of a collision, which may increase the risk of injury.
- Flashing or flickering of the warning
light
- No illumination of the warning
light when the ignition switch is
first turned to the “ON” position
- Continuous illumination of the
warning light
- Illumination of the warning light
while driving
See also:
Meter needles/gauge illumination setting (models with type A combination
meter)
When the setting is activated or deactivated,
the meter needles and gauge
illuminate and turn off as follows.
Activated:
When the driver’s door is opened while
the ignition switch is in the “L ...
Hazard warning flasher
The hazard warning flasher is used to warn other drivers when you have to park
your vehicle under emergency conditions. The hazard warning flasher works with the
ignition switch in any position. ...
Starting your vehicle
The remote engine start system is activated by pressing the “” button twice within 3 seconds on your remote engine start transmitter. The system will check certain pre-conditions before starting, an ...