Valet mode
When you choose the valet mode, the alarm system does not operate. In valet mode, the remote transmitter is used only for locking and unlocking the doors and rear gate and panic activation.
To enter the valet mode, change the setting of your vehicle’s alarm system for deactivation mode. Refer to “Activating and deactivating the alarm system”. The security indicator light will continue to flash once every 3 seconds indicating that the system is in the valet mode.
To exit valet mode, change the setting of your vehicle’s alarm system for activation mode. Refer to “Activating and deactivating the alarm system”.
See also:
Vehicle placard
The vehicle placard is affixed to the
driver’s side B-pillar.
Example:
The vehicle placard shows original
tire size, recommended cold tire
inflation pressure on each tire at
maximum load ...
Setting guidance volume
To set the guidance volume, perform the following procedure.
1. Select the “SETUP” menu.
2. Select the “SYSTEM SETUP” menu.
3. Select “GUIDANCE VOL” by operating the “TUNE/TRACK/CH” dial.
4. Set t ...
To set cruise control
1. Push the “CRUISE” main switch button.
Turbo models
Non-turbo models
The cruise control indicator light on the combination meter will illuminate.
2. Depress the accelerator pedal until the veh ...