To arm the system using remote transmitter
1. Close all windows and the moonroof (if equipped).
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood is locked.
5. Close all doors and the rear gate.

: Press
to Disarm the system.
: Press to Arm the system.

Type A

Type B
6. Briefly press the “
” button
(for less
than 2 seconds). All doors and the rear
gate will lock, an electronic chirp will
sound once, the turn signal lights will flash
once, and the security indicator light will
start flashing rapidly. After rapid flashing
for 30 seconds (standby time), the security
indicator light will then flash slowly (twice
approximately every 2 seconds), indicating
that the system has been armed for
surveillance.
If any of the doors or the rear gate is not fully closed, an electronic chirp sounds five times, the turn signal lights flash five times to alert you that the doors or the rear gate are not properly closed. When you close the door, the system will automatically arm and the doors will be automatically locked.
See also:
Safety
The 2010 Subaru Outback has been named a 2010 Top Safety Pick by the
Insurance Institute for Highway Safety. To earn this award, a car must get the
top score of Good in frontal-offset, side-impact ...
Cruise control
Cruise control enables you to maintain a constant vehicle speed without holding
your foot on the accelerator pedal and it is operative when the vehicle speed is
25 mph (40 km/h) or more.
WARNING
...
Tire pressure monitoring system (TPMS) (if equipped)
The tire pressure monitoring system provides the driver with a warning message
by sending a signal from a sensor that is installed in each wheel when tire pressure
is severely low.
The tire pre ...
