Front fog light switch (if equipped)

Subaru Legacy / Subaru Legacy Owners Manual / Instruments and controls / Front fog light switch (if equipped)

The front fog lights operate under the following conditions.


The front fog lights operate under the following conditions.

● when the light switch is in the “position”
position
● when the light switch is in the “AUTO” position and the headlights turn on automatically

However, the front fog lights turn off when the headlights are switched to high beam.

To turn on the front fog lights, turn the front fog light switch on the turn signal lever upward to the “To turn off the front fog lights, turn the switch back down to the “OFF” position.” position.
To turn off the front fog lights, turn the switch back down to the “OFF” position.

The indicator light located on the combination meter will illuminate when the


The indicator light located on the combination meter will illuminate when the front fog lights are on.

    See also:

    Entering the vehicle following remote engine start shutdown
    An alarm trigger may occur if the vehicle is opened by the remote keyless entry transmitter within a few seconds immediately following remote engine start shutdown. ...

    Changing the remote control batteries
    - Do not let dust, oil or water get on or in the remote engine start transmitter when replacing the battery. - Be careful not to damage the printed circuit board in the remote engine st ...

    To turn off the cruise control
    There are two ways to turn off the cruise control: • Push the “CRUISE” main switch button again. • Turn the ignition switch to the “Acc” or “LOCK” position (but only when the vehicle is completely s ...