Canceling the function for meter/gauge needle movement upon turning on the ignition switch

It is possible to activate or deactivate the movement of the meter needles and gauge needles that takes place when the ignition switch is turned to the “ON” position.
1. Turn the ignition switch to the “LOCK” or “Acc” position.
2. Press the trip knob to show “ ” or “ ” on the trip meter display
The display can be switched as shown in the following illustration by pressing the trip knob.

3. To change the current setting, press the trip knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
● Your vehicle’s initial movement setting of the meter/gauge needles has been set for activation “ ” at the time of shipment from the factory.
● It is not possible to change the initial movement setting of the meter/gauge needles when the ignition switch is in the “ON” position. Change the setting when the ignition switch is in the “LOCK” or “Acc” position.
See also:
Illuminated entry
The interior (dome) light and the map light
will illuminate when the “”
button is
pressed. These lights stay illuminated for
approximately 30 seconds if any of the
doors or the rear gate is ...
Stereo indicator
The stereo indicator “ST” will illuminate when an FM stereo broadcast is received. ...
Certification for the Handsfree system
FCC WARNING
Changes or modifications not expressly
approved by the party responsible
for compliance could void
the user’s authority to operate the
equipment.
NOTE
This device complies ...
