Combination meter illumination

When the ignition switch is turned to the “ON” position, the various parts of the combination meter are illuminated in the following sequence.

1. Warning lights, indicator lights, meter needles, gauge needles, odometer and trip meter back light illuminate.

2. Meter needles and gauge needles each show MAX position.

3. Meter needles and gauge needles each show MIN position.

4. Dials and indicators in meters and gauges light up.

5. Regular illumination (for driving) begins.

NOTE

The above sequence of operations may not take place if you quickly turn the ignition switch to start the engine. This is not a malfunction.

    See also:

    Pre-heating or pre-cooling the interior of the vehicle
    Models with automatic climate control system: After the system starts the engine, the automatic climate control system will activate the “FULL AUTO” mode and heat or cool the interior to the predet ...

    Menu list of the Hands-free system
    Turn the “TUNE/TRACK/CH” dial to select a menu, and then press the dial to enter the selected menu. *: If a cell phone is not registered, the menu described in the chart is not indicated. ...

    Compass zone adjustment
    Compass calibration zones 1. Refer to the “Compass calibration zones” map shown above to verify that the compass zone setting is correct for your geographical location. 2. Press and hold the com ...