Subaru Outback (BR): Main fuse
Main fuse box
The main fuses are designed to melt during an overload to prevent damage to the wiring harness and electrical equipment. Check the main fuses if any electrical component fails to operate (except the starter motor) and other fuses are good. A melted main fuse must be replaced. Use only replacements with the same specified rating as the melted main fuse. If a main fuse blows after it is replaced, have the electrical system checked by your nearest SUBARU dealer.
READ NEXT:
Replacing bulbs
WARNING
Bulbs may become very hot while illuminated. Before replacing bulbs, turn off
the lights and wait until the bulbs cool down, Otherwise, there is the risk of sustaining
a burn injury.
CAU
Headlight
CAUTION
Halogen headlight bulbs become very hot while in use. If you touch the bulb surface
with bare hands or greasy gloves, fingerprints or grease on the bulb surface will
develop into hot spot
SEE MORE:
Total trailer weight
Total trailer weight
The total trailer weight (trailer weight plus its cargo load) must never exceed
the maximum weight.
Outback
The maximum total trailer weight is indicated in the following tables.
Center Differential Carrier
A: REMOVAL
1) Remove the transmission assembly from the vehicle.
<Ref. to 5AT-37, REMOVAL, Automatic
Transmission Assembly.>
2) Remove the rear vehicle speed sensor, and separate
the extension case from transmission case.
<Ref. to 5AT-65, REMOVAL, Extension Case.>
3) Extract the rear
© 2010-2024 Copyright www.suoutback.com
