Subaru Outback (BR): Windshield wiper blade rubber
1) Support
1. Grasp the locked end of the blade rubber assembly and pull it firmly until
the stoppers on the rubber are free of the support.
1) Metal spines
2. If the new blade rubber is not provided with two metal spines, remove the
metal spines from the old blade rubber and install them in the new blade rubber.
3. Align the claws of the support with the grooves in the rubber and slide the
blade rubber assembly into the support until it locks.
1) Claw
2) Stopper
4. Be sure to position the claws at the end of the support between the stoppers
on the rubber as shown. If the rubber is not retained properly, the wiper blade
may scratch the windshield.
READ NEXT:
1. Raise the wiper arm off the rear window.
2. Turn the wiper blade assembly counterclockwise.
3. Pull the wiper blade assembly toward you to remove it from the wiper arm.
1. Pull out the end of the blade rubber assembly to unlock it from the plastic
support.
2. Pull the blade rubber assembly out of the plastic support.
1) Metal spines
3. If the new blade rub
Before starting any work near a battery, it's crucial to ensure that all sources of ignition, such as cigarettes, matches, and lighters, are completely extinguished. This precaution is vital because b
SEE MORE:
When the ignition switch is turned to the “ON” position, the various parts of
the combination meter are illuminated in the following sequence.
1. Warning lights, indicator lights, meter needles, gauge needles, odometer and
trip meter back light illuminate.
2. Meter needles and gauge needle
CAUTION
● Do not use ashtrays as waste receptacles or leave a lighted cigarette in an
ashtray. This could cause a fire.
● Always extinguish matches and cigarettes before putting them into the ashtray,
and then close the ashtray securely. If you keep the ashtray open, the fire of th
© 2010-2024 Copyright www.suoutback.com