Subaru Outback (BR): Breaking-in of new brake pads and linings
Subaru Outback (BR) 2010-2015 Owners Manual / Maintenance and service / Replacement of brake pad and lining / Breaking-in of new brake pads and linings
When replacing the brake pad or lining, use only genuine SUBARU parts. After replacement, the new parts must be broken in as follows:
READ NEXT:
Brake pad and lining
While maintaining a speed of 30 to 40 mph (50 to 65 km/h), step on the brake
pedal lightly. Repeat this five or more times.
Parking brake lining
The break-in maintenance for the parking brake linings should be performed at
a SUBARU dealer.
SEE MORE:
Drive Pinion Shaft Assembly in Continuously Variable Transmission
A: REMOVAL
1) Remove the transmission assembly from the vehicle. <Ref. to CVT-55, REMOVAL, Automatic Transmission Assembly.>
2) Remove the air breather hose. <Ref. to CVT-132, REMOVAL, Air Breather Hose.>
3) Remove the oil pan and control valve body. <Ref. to CVT-111, REMOVAL, Con
Automatic Transmission Assembly
A: REMOVAL
1) Remove the front wheels.
2) Fully open the front hood.
3) Disconnect the ground cable from battery.
4) Remove the collector cover.
NOTE:
Follow the steps below when removing the collector
cover.
Pull up the two points at the rear (A).
Pull up the two points at the front (B) whil
© 2010-2024 Copyright www.suoutback.com
