Subaru Outback (BR): Check the fluid level monthly.
1. Drive the vehicle several miles to raise the temperature of the transmission
fluid up to normal operating temperature; 158 to 1768F (70 to 808C) is normal.
2. Park the vehicle on a level surface and set the parking brake.
3. First shift the select lever in each position. Then shift it in the “P” position,
and run the engine at idling speed.
1) Yellow handle
1) HOT range
2) COLD range
3) Upper level
4) Lower level
4. Pull out the level gauge and check the fluid level on the gauge. If it is
below the lower level on the “HOT” range, add the recommended automatic transmission
fluid up to the upper level.
READ NEXT:
When the fluid level has to be checked without time to warm up the automatic
transmission, check to see that the fluid level is between the lower level and upper
level on the “COLD” range. If
NOTE
Using any non-specified type of automatic transmission fluid could result in
damage inside the transmission. When replacing the automatic transmission fluid,
be sure to use the specified typ
There is no fluid level gauge. It is unnecessary to check the continuously variable
transmission fluid level. However, if necessary, consult your SUBARU dealer for
inspection.
SEE MORE:
The security indicator light deters potential thieves by indicating that the
vehicle is equipped with an immobilizer system. It begins flashing approximately
60 seconds after the ignition switch is turned from the “ON” position to the “Acc”
or “LOCK” position or immediately after
A: INSPECTION
Inspect there is no ATF leakage from the joint of
transmission and propeller shaft. If a leak is found,
replace the oil seal. <Ref. to 5AT-48, REPLACEMENT,
Extension Case Oil Seal.>
B: REPLACEMENT
1) Lift up the vehicle.
2) Clean the transmission exterior.
3) Remove the ATF dra
© 2010-2024 Copyright www.suoutback.com