Subaru Outback (BR): Removing and reinstalling clips
Removing clips
There are several types of clips used for your vehicle
Type A clips
1. Turn the clips counterclockwise using a flat-head screwdriver until the center
portion of the clip is raised.
2. Remove the clips with a flat-head screwdriver using leverage.
Type B clips
1. Pull out the center portion of the clip using a flat-head screwdriver as shown
in the illustration.
2. Pull the protruded center portion to remove the entire body of the clip.
Type C clips
1. Turn the clip counterclockwise using a Phillips screwdriver until the center
portion of the clip is raised.
2. Remove the entire clip by pulling it up.
Reinstalling clips
Type A clips
Type B clips
Type C clips
Insert the clip without the center portion first and then push the center portion
of the clip into the hole.
READ NEXT:
Use a screwdriver to undo the clips on the air intake duct, then remove the air
intake duct. Refer to “Type A clips” F11-5.
It is necessary to pull off the fender lining when replacing some bulbs.
1. Start the engine and turn the steering wheel fully in the opposite direction
of the bulb to be replaced.
2. Stop the eng
To open the hood:
1. If the wiper blades are lifted off the windshield, return them to their original
positions.
2. Pull the hood release knob under the instrument panel.
3. Release the secon
SEE MORE:
A: REMOVAL
1) After disconnecting the battery ground terminal, remove the terminal cover, then disconnect the positive terminal.
2) Remove the battery cable holder from the battery rod.
3) Remove flange nut from the battery rod and remove battery holder.
Remove the battery.
B: INSTALLATION
1) Rear window defogger
2) Outside mirror defogger (if equipped)
3) Windshield wiper deicer (if equipped)
The vehicle is equipped with a rear window defogger. Some models are also equipped
with an outside mirror defogger and/or windshield wiper deicer. The defogger and
deicer system is acti
© 2010-2024 Copyright www.suoutback.com