Subaru Outback (BR): Snow tires
WARNING
● When replacing original tires with winter (snow) tires, make sure you use only the same size, construction and load range as the original tires listed on the tire placard. Using other sizes and construction may affect speedometer/ odometer calibration and clearance between the body and tires. It also may be dangerous and lead to loss of vehicle control.
● You must install four winter tires that are of the same size, circumferences, construction, brand, and load range. Mixing other sizes, circumferences or constructions may result in severe mechanical damage to the drive train of your vehicle and may affect ride, handling, braking and speedometer/odometer calibration. It also may be dangerous and lead to loss of vehicle control.
● Do not use a combination of radial, belted bias or bias tires since it may cause dangerous handling characteristics and lead to an accident.
READ NEXT:
Except 2.5 L turbo models
Your vehicle is equipped with “all season tires” which are designed to provide
an adequate measure of traction, handling and braking performance in year-round
driving. In winter, it may be pos
Winter driving on 2.5 L turbo models
Original equipment summer tires are installed on your vehicle, which are not suitable for driving on slippery surfaces like snow-covered or icy roads. Compared to winter and all-season tires, summer t
Tire chains
CAUTION
Tire chains cannot be used on any tires for your Legacy and Outback because of
lack of clearance between the tires and vehicle body.
SEE MORE:
Stop Light Switch
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the instrument panel lower cover.
Remove the clips, and remove the instrument panel side cover LH.
Remove the clips and data link connector, and remove the instrument
panel lower cover under.
Remove the bolts, and remove
Compass zone adjustment
Compass calibration zones
1. Refer to the “Compass calibration zones” map shown above to verify that the
compass zone setting is correct for your geographical location.
2. Press and hold the compass display button for 3 seconds until the zone selection
comes up (a number will be displaye
