Subaru Outback (BR): Cruise control activation indicator light
Subaru Outback (BR) 2010-2015 Owners Manual / Starting and operating / Cruise control / Cruise control activation indicator light
The indicator light for cruise control activation illuminates upon turning the ignition switch to the “ON” position and remains lit for around 3 seconds.
This light becomes illuminated when the vehicle speed has been successfully set using the cruise control function.
READ NEXT:
New vehicle break-in driving – the first 1,000 miles (1,600 km)
The performance and long life of your vehicle are dependent on how you handle
and care for your vehicle while it is new. Follow these instructions during the
first 1,000 miles (1,600 km):
●
Fuel economy hints
The following suggestions will help to save your fuel.
● Select the proper gear position for the speed and road conditions.
● Avoid sudden acceleration or deceleration. Always accelerate
SEE MORE:
Clutch Pipe and Hose
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the collector cover. (turbo model)
3) Remove the air intake boot assembly. (non-turbo
model) <Ref. to IN(H4SO)-8, REMOVAL, Air Intake
Boot.>
4) Remove the intercooler. (turbo model) <Ref. to
IN(H4DOTC)-17, REMOVAL, Intercoo
Malfunction Indicator Light
A: PROCEDURE
B: ACTIVATION OF MALFUNCTION
INDICATOR LIGHT
1) When the ignition switch is turned to ON (engine
OFF), the malfunction indicator light (A) in the combination
meter illuminates.
NOTE:
If the malfunction indicator light does not illuminate,
perform diagnostics of the malfunction indicat
© 2010-2024 Copyright www.suoutback.com
