Subaru Outback (BR): Cruise control
Cruise control enables you to maintain a constant vehicle speed without holding your foot on the accelerator pedal and it is operative when the vehicle speed is 25 mph (40 km/h) or more.
WARNING
Do not use the cruise control under any of the following conditions. These may cause loss of vehicle control.
● driving up or down a steep grade ● driving on slippery or winding roads ● driving in heavy traffic ● towing a trailer
NOTE
● If you press the “CRUISE” main switch button while turning the ignition switch “ON”, the cruise control function is deactivated and the cruise control indicator light flashes. To reactivate the cruise control function, turn the ignition switch back to the “Acc” or “LOCK” position, and then turn it again to the “ON” position.
● Make sure the “CRUISE” main switch is turned off when the cruise control is not in use to avoid unintentionally setting of the cruise control.
- To set cruise control
- To temporarily cancel the cruise control
- To turn off the cruise control
- To change the cruising speed
- Cruise control indicator light
- Cruise control activation indicator light
READ NEXT:
To set cruise control
1. Press the “CRUISE” main switch button.
The cruise control indicator light on the combination meter will illuminate.
2. Depress the accelerator pedal until the vehicle reaches the desired
To temporarily cancel the cruise control
The cruise control can be temporarily canceled in the following ways.
● Press the “CANCEL” button.
● Depress the brake pedal.
● Depress the clutch pedal (MT models only).
&
To turn off the cruise control
There are two ways to turn off the cruise control:
● Press the “CRUISE” main switch button again.
● Turn the ignition switch to the “Acc” or “LOCK” position (but only when th
SEE MORE:
Pre-delivery Inspection
A: GENERAL DESCRIPTION
The purposes of the pre-delivery inspection (PDI) are as follows.
Remove the additional parts used for ensuring the vehicle quality during
transportation and restore the vehicle
to its normal condition.
Check the vehicle before delivery is in normal condition.
Check the
Vehicle Dynamics Control OFF indicator light
The light illuminates when the ignition switch is turned to the “ON” position
and turns off after approximately 2 seconds. The light illuminates when the Vehicle
Dynamics Control OFF switch is pressed to deactivate the Vehicle Dynamics Control
system.
The Vehicle Dynamics Control system
