Subaru Outback (BR): Parking tips
When parking your vehicle, always perform the following items.
● Apply the parking brake.
● For MT models, put the shift lever in the “1” (1st) for upgrade or “R” (Reverse)
for a downgrade.
● For AT and CVT models, put the select lever in the “P” (Park) position. Never
rely on the transmission alone to hold the vehicle.
When parking on a hill, always turn the steering wheel as described here. When
the vehicle is headed up the hill, the front wheels should be turned away from the
curb.
When facing downhill, the front wheels should be turned into the curb.
READ NEXT:
Cruise control enables you to maintain a constant vehicle speed without holding
your foot on the accelerator pedal and it is operative when the vehicle speed is
25 mph (40 km/h) or more.
WARNING
1. Press the “CRUISE” main switch button.
The cruise control indicator light on the combination meter will illuminate.
2. Depress the accelerator pedal until the vehicle reaches the desired
The cruise control can be temporarily canceled in the following ways.
● Press the “CANCEL” button.
● Depress the brake pedal.
● Depress the clutch pedal (MT models only).
&
SEE MORE:
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Using the refrigerant recovery system, discharge refrigerant. <Ref. to AC-24,
PROCEDURE, Refrigerant
Recovery Procedure.>
3) Remove the connector and bolts, and remove the high-pressure hose and AC pipe
from the expansion
valve.
4
When the ignition switch is turned to the “ON” position, the low tire pressure
warning light will illuminate for approximately 2 seconds to check that the tire
pressure monitoring system (TPMS) is functioning properly. If there is no problem
and all tires are properly inflated, the light
© 2010-2024 Copyright www.suoutback.com