Subaru Outback (BR): Automatic release function by accelerator pedal
The electronic parking brake system has an automatic release function. The parking
brake will be automatically released by depressing the accelerator pedal. However,
the automatic release function does not operate under the following conditions.
● Any door (other than the trunk lid or rear gate) is open.
● The driver’s seatbelt is not fastened. If the parking brake is automatically
released, the brake system warning light and the indicator on the parking brake
switch turn off.
NOTE
Even if you have applied the parking brake by pressing the parking brake switch,
the parking brake will be automatically released when the accelerator pedal is depressed.
READ NEXT:
The electronic parking brake system has a Hill Holder function. If the Hill Holder
function is activated, the parking brake will be automatically applied when stopping
on an uphill slope with the
CAUTION
Use the emergency brake only in case of an emergency. If the emergency brake
is excessively used, the brake parts will wear down faster or the brake may not
work sufficiently due to rear
When parking your vehicle, always perform the following items.
● Apply the parking brake.
● For MT models, put the shift lever in the “1” (1st) for upgrade or “R” (Reverse)
for
SEE MORE:
Legacy
Outback
A rear view camera is attached to the trunk lid (Legacy) or rear gate (Outback).
When the ignition switch is “ON” and the shift lever (MT models) or select lever
(AT or CVT models) is set to “R”, the rear view camera automatically displays the
rear view image behin
A: ELECTRICAL SPECIFICATION
Input/output name:
Crankshaft position sensor
Camshaft position sensor
Measuring condition:
After warming-up
At idling
Engine Condition Data
A: ELECTRICAL SPECIFICATION
Measuring condition:
After engine is warmed up.
Set the select lever in "P" range
© 2010-2024 Copyright www.suoutback.com