Subaru Outback (BR): Two separate circuits
Subaru Outback (BR) 2010-2015 Owners Manual / Starting and operating / Braking / Brake system / Two separate circuits
Your vehicle has a dual circuit brake system. Each circuit works diagonally across the vehicle. If one circuit of the brake system should fail, the other half of the system still works. If one circuit fails, the brake pedal will go down much closer to the floor than usual and you will need to press it down much harder. And a much longer distance will be needed to stop the vehicle.
READ NEXT:
Brake assist system
WARNING
Do not be overconfident about the brake assist. It is not a system that brings
more braking ability to the vehicle beyond its braking capability. Always use the
utmost care when driving r
Disc brake pad wear warning indicators
The disc brake pad wear warning indicators on the disc brakes give a warning
noise when the brake pads are worn.
If a squeaking or scraping noise is heard from the disc brakes while braking,
im
SEE MORE:
Service mode
In service mode, the remote engine start function is temporarily disabled to
prevent the system from unexpectedly starting the engine while being serviced.
To engage or disengage service mode:
1. Enter the vehicle and close all vehicle doors and the trunk/rear gate.
2. Verify that the select le
If the light illuminates constantly
If the light illuminates constantly while driving or does not turn off after
the engine starts, an emission control system malfunction has been detected.
You should have your vehicle checked by an authorized SUBARU dealer immediately.
NOTE
This light also illuminates when the fuel filler cap is
© 2010-2024 Copyright www.suoutback.com
