Subaru Outback (BR): Driving tips when using a Automatic transmission or Continuously variable transmission
● On a road surface where there is a risk of wheelspin (for example, a snow- or gravel-covered road), you can pull away from a standstill safely and easily by first selecting the 2nd gear of the manual mode.
● Always apply the foot or parking brake when the vehicle is stopped in the “D” or “R” position.
● Always apply the parking brake when parking your vehicle. Do not hold the vehicle with only the transmission.
● Do not keep the vehicle in a stationary position on an uphill grade by using the “D” position. Use the brake instead.
● The engine may, on rare occasions, knock when the vehicle rapidly accelerates or rapidly pulls away from a standstill. This phenomenon does not indicate a malfunction.
● A slight reduction in output torque may occur in the models with a 2.5 L turbo or 3.6 L engine before the engine warms up.
READ NEXT:
Power steering
CAUTION
Do not hold the steering wheel at the fully locked position left or right for
more than 5 seconds. This may damage the power steering pump.
The power steering system operates only when the
Braking tips
WARNING
Never rest your foot on the brake pedal while driving. This can cause dangerous
overheating of the brakes and needless wear on the brake pads and linings.
SEE MORE:
Roof Trim
A: REMOVAL
1. SEDAN MODEL
1) Remove the rear seat cushion assembly.
Pull up the seat cushion and release the hook.
CAUTION:
If the hook is disconnected from the vehicle body, replace the hook with the new
part to prevent the
decline of the fixed force of the seat.
Remove the hook (A) by push
Side Airbag Module
A: REMOVAL
CAUTION:
Refer to "CAUTION" of "General Description" before handling the airbag module.
<Ref. to AB-9,
CAUTION, General Description.>
NOTE:
Remove the passenger's side by referring to driver's side.
1) Remove the headrest.
NOTE:
For models with headrest monitor, remove the headrest
