Subaru Outback (BR): Shift lock release using the shift lock release button
Perform the following procedure to release the shift lock.
1. Apply the parking brake and stop the engine.
2. Remove the shift lock cover using a flat-head screwdriver.
3. While depressing the brake pedal, insert the electronic parking brake release
tool into the hole, press the shift lock release button using the tool, and then
move the select lever.
NOTE
To prevent damage to the shift lock cover, cover the tip of the flat-head screwdriver
with vinyl tape or a cloth before removing the cover.
If the select lever does not move after performing the above procedure, the shift
lock system may be malfunctioning. Contact a SUBARU dealer for an inspection as
soon as possible.
READ NEXT:
With the vehicle either moving or stationary, move the select lever from the
“D” position to the “M” position to select the manual mode.
1) Upshift indicator
2) Downshift indicator
3)
● On a road surface where there is a risk of wheelspin (for example, a snow- or gravel-covered road), you can pull away from a standstill safely and easily by first selecting the 2nd gear of the m
CAUTION
Do not hold the steering wheel at the fully locked position left or right for
more than 5 seconds. This may damage the power steering pump.
The power steering system operates only when the
SEE MORE:
AR:DTC P0171 SYSTEM TOO LEAN (BANK 1)
1. OUTLINE OF DIAGNOSIS
Detect fuel system malfunction by the amount of main feedback control.
Diagnostic method
Fuel system is diagnosed by comparing the target air fuel ratio calculated by
ECM with the actual air fuel ratio
measured by sensor.
2. ENABLE CONDI
A: REMOVAL
1. SEDAN MODEL
CAUTION:
Refer to "CAUTION" of "General Description" before handling the airbag module.
<Ref. to AB-9,
CAUTION, General Description.>
1) Turn the ignition switch to OFF.
2) Disconnect the ground cable from battery and wait for at least 60 seconds
before starting wo
© 2010-2024 Copyright www.suoutback.com