Subaru Outback (BR): Shift lock release
If the select lever cannot be operated, turn the ignition switch back to the “ON” position then move the select lever to the “P” position with the select lever button pressed and brake pedal depressed. If the select lever does not move after performing the above procedure, perform the following steps.
● When the select lever cannot be shifted from “P” to “N”:
Refer to “Shift lock release using the shift lock release button” F7-21.
● When the select lever cannot be shifted from “N” to “R”, “P”:
Within 60 seconds after placing the ignition switch in the “Acc” position, move the select lever to the “P” position with the select lever button pressed and brake pedal depressed.
If you must perform the above procedure, the shift lock system (or the vehicle control system) may be malfunctioning. Contact a SUBARU dealer for an inspection as soon as possible.
If the select lever does not move after performing the above procedure, refer to “Shift lock release using the shift lock release button” F7-21.
READ NEXT:
Shift lock release using the shift lock release button
Perform the following procedure to release the shift lock.
1. Apply the parking brake and stop the engine.
2. Remove the shift lock cover using a flat-head screwdriver.
3. While depressing the
Selection of manual mode
With the vehicle either moving or stationary, move the select lever from the
“D” position to the “M” position to select the manual mode.
1) Upshift indicator
2) Downshift indicator
3)
Driving tips when using a Automatic transmission or Continuously variable transmission
● On a road surface where there is a risk of wheelspin (for example, a snow- or gravel-covered road), you can pull away from a standstill safely and easily by first selecting the 2nd gear of the m
SEE MORE:
Clock
NOTE
Your SUBARU dealer can change the settings of activating/deactivating the automatic
adjustment of the clock by the GPS (Global Positioning System) (for models with
the genuine SUBARU navigation system). Contact your SUBARU dealer for details.
The clock shows the time while the ignition
Tone and balance control
Each brief press of the “TUNE/TRACK/ CH” dial changes the control modes in the
following sequence.
Choose the desired level for each mode by turning the “TUNE/TRACK/CH” dial. The
control function returns to the tune/ track/channel control mode after approximately
5 seconds.
