Subaru Outback (BR): P (Park)
This position is for parking the vehicle and starting the engine.
In this position, the transmission is mechanically locked to prevent the vehicle from rolling freely.
When you park the vehicle, first apply the parking brake, then shift into the “P” position. Do not hold the vehicle with only the transmission.
To shift the select lever from the “P” to any other position, you should depress the brake pedal fully then move the select lever. This prevents the vehicle from lurching when it is started.
NOTE
To protect the engine while the “P” position is selected, the engine is controlled such that the engine speed may not become too high even if the accelerator pedal is depressed hard.
READ NEXT:
R (Reverse)
This position is for backing the vehicle. To shift from the “N” to “R” position,
stop the vehicle completely then move the lever to the “R” position.
N (Neutral)
This position is for restarting a stalled engine.
In this position the wheels and transmission are not locked. In this position,
the transmission is neutral; the vehicle will roll freely, even on t
D (Drive)
This position is for normal driving. The transmission automatically shifts into
a suitable gear according to the vehicle speed and the acceleration you require.
When more acceleration is required
SEE MORE:
DTC P0327, P0328, P0335, P0336, P0340, P0341, P0351, P0352, P0353, P0354,
P0400, P0420
BJ:DTC P0327 KNOCK SENSOR 1 CIRCUIT LOW (BANK 1 OR SINGLE SENSOR)
1. OUTLINE OF DIAGNOSIS
Detect the open or short circuit of knock sensor.
Judge as NG if out of specification.
2. COMPONENT DESCRIPTION
To knock sensor harness
Case
Weight
Piezoelectric element
Nut
Resistance
3. ENABLE CON
Preset buttons
How to preset channels
1. Press the “SAT” button to select SAT1, SAT2 and SAT3 reception.
2. Select the desired channel.
3. Press one of the preset buttons for more than 1.5 seconds to store the channel.
If the button is pressed for less than 1.5 seconds, the preceding selection will
rema
© 2010-2024 Copyright www.suoutback.com
