Subaru Outback (BR): Selecting reverse gear
CAUTION
Shift into reverse ONLY when the vehicle has completely stopped. It may cause
damage to the transmission to try shifting into reverse when the vehicle is moving.
1) Slider
You must raise the slider and hold it in that position before you can move the
shift lever to the “R” position.
To change gears, fully depress the clutch pedal, move the shift lever, and gradually
let up on the clutch pedal.
If it is difficult to shift into gear, put the transmission in neutral, release
the clutch pedal momentarily, and then try again.
READ NEXT:
The best compromise between fuel economy and vehicle performance during normal
driving is ensured by shifting up at the speeds listed in the following table.
WARNING
When shifting down a gear, ensure that the vehicle is not travelling at a speed
exceeding the Maximum Allowable Speed for the gear which is about to be selected.
Failure to observe this p
SEE MORE:
WARNING
● Never inhale engine exhaust gas. Engine exhaust gas contains carbon monoxide,
a colorless and odorless gas which is dangerous, or even lethal, if inhaled.
● Always properly maintain the engine exhaust system to prevent engine exhaust gas
from entering the vehicle.
●
A: PROCEDURE
Check List for Interview
A: CHECK
Identification
A: PROCEDURE
Identify the vehicle using the chassis number, part number of the airbag control module or Subaru Select Monitor.
NOTE: Proper identification is necessary to ensure proper diagnosis. Components are not interchange
© 2010-2024 Copyright www.suoutback.com