Subaru Outback manuals

Subaru Outback: Service mode

In service mode, the remote engine start function is temporarily disabled to prevent the system from unexpectedly starting the engine while being serviced.

To engage or disengage service mode:

1. Enter the vehicle and close all vehicle doors and the trunk/rear gate.

2. Verify that the select lever is in the “P” position (AT and CVT models) 3. Depress and hold the brake pedal 4. Turn the ignition switch to the “ON” position 5. Press and release the remote engine start transmitter “button three times. The system will honk the vehicle’s horn each time the button
button three times. The system will honk the vehicle’s horn each time the button is pressed.

6. The system will pause for 1 second then honk the vehicle’s horn three times to indicate that the service mode has been engaged or honk one time to indicate that the service mode has been disengaged.

NOTE

When taking your vehicle in for service, it is recommended that you inform the service personnel that your vehicle is equipped with a remote engine start system.

READ NEXT:

 Remote transmitter program

New transmitters can be programmed to the remote engine start system in the event that a transmitter is lost, stolen, damaged or additional transmitters are desired (the system will accept up to e

 System maintenance

NOTE In the event that the vehicle’s battery is replaced, discharged or disconnected, it will be necessary to start the vehicle a minimum of one time using the key prior to activating the remot

 Changing the batteries

CAUTION ● Do not let dust, oil or water get on or in the remote engine start transmitter when replacing the battery. ● Be careful not to damage the printed circuit board in the remote

SEE MORE:

 Tire Identification Number (TIN)

Tire Identification Number (TIN) is marked on the intended outboard sidewall. The TIN is composed of four groups. Here is a brief review of the TIN with a breakdown of its individual elements. (1) Manufacturer’s Identification Mark (2) Tire Size (3) Tire Type Code (4) Date of Manufacture

 Rear Gate

A: REMOVAL CAUTION: Rear gate panels are heavy. When removing and installing them, always work in a team of two or more persons. 1. REAR GATE PANEL 1) Disconnect the ground cable from battery. 2) Remove the following parts. <Ref. to EI-164, REMOVAL, Rear Gate Garnish.> Rear gate trim Rear

© 2010-2024 Copyright www.suoutback.com