Subaru Outback (BR): Entering the vehicle while it is running via remote start
1. Unlock the vehicle doors using the remote keyless entry system. If the vehicle’s
doors are unlocked manually using the key, the vehicle’s alarm system will trigger
(if the alarm system is armed prior to activating the remote engine start system)
and the engine will turn off. Inserting the key into the ignition switch and turning
it to the “ON” position or pressing the unlock button “”
on the remote keyless entry transmitter will disarm the alarm system. Refer to “Alarm
system” F2-15.
2. Enter the vehicle.
3. The engine will shut down when any door or trunk/rear gate is opened.
4. Insert the key into the ignition switch and turn to the “START” position to
restart the engine.
READ NEXT:
Your remote engine start transmitter is equipped with a unique bidirectional
confirmation feature. This feature will allow the transmitter’s backlit button to
display the status of the system un
An alarm trigger may occur if the vehicle is opened by the remote keyless entry
transmitter within a few seconds immediately following remote engine start shutdown.
Models with automatic climate control system:
After the system starts the engine, the automatic climate control system will
activate the “FULL AUTO” mode and heat or cool the interior to the pr
SEE MORE:
The tire pressure monitoring system alerts the driver by transmitting a signal from a sensor in each wheel when tire pressure drops significantly.
This system activates when the vehicle reaches speeds above 20 mph (32 km/h) and may not respond immediately to sudden drops in tire pressure,
Each airflow control button activates the following air outlets.
: Instrument panel outlets
: Instrument panel outlets and foot
outlets
: Foot outlets, both side outlets of
the instrument panel and some through windshield defroster outlets (A small amount
of air flows to the windshield
© 2010-2024 Copyright www.suoutback.com