Subaru Outback (BR): To install the cover housing
1. To install the cover housing, insert both ends of the cover housing into the
retainers.
2. Make sure to fix the front part of the cargo area cover behind the rear seat.
READ NEXT:
CAUTION
The convenient tie-down hooks are designed only for securing light cargo. Never
try to secure cargo that exceeds the capacity of the hooks. The maximum load capacity
is 44 lbs (20 kg) per
The subfloor storage compartment is located under the floor of the trunk or cargo
area and can be used to store small items. To open the lid, pull the tab or handle
up.
NOTE
When storing a flat
Legacy
Outback
A rear view camera is attached to the trunk lid (Legacy) or rear gate (Outback).
When the ignition switch is “ON” and the shift lever (MT models) or select lever
(AT or CV
SEE MORE:
A: REMOVAL
1) Lift up the vehicle, and then remove the front wheels.
2) Remove the left and right stabilizer brackets.
3) Remove the ball joint.
Extract the cotter pin (a) from the ball stud.
Remove the castle nut (b).
Extract the ball stud from the front arm.
Remove the bolt securing the bal
A: OPERATION
1) While the ABS sequence control is being performed, the operation of the
hydraulic unit can be checked using
the brake tester or pressure gauge after the hydraulic unit solenoid valve
operation.
2) ABS sequence control can be started by the Subaru Select Monitor.
1. ABS SEQUENCE CO
© 2010-2024 Copyright www.suoutback.com