Subaru Outback (BR): Floor mat
Retaining pins are located on the driver’s side floor.
The floor mat is secured using the built-in grommets, by placing the grommets
over the pins and pushing them downward.
CAUTION
Make sure the driver’s floor mat is placed back in its proper location and correctly
secured on its retaining pin. Also, do not use more than one floor mat. If the floor
mat slips forward and interferes with the movement of the pedals during driving,
it could cause an accident.
READ NEXT:
The cargo area cover is provided for covering the cargo area and to protect its
contents from direct sunlight. This cover is detachable to make room for additional
cargo.
To extend the cover, pull the end of the cover out of the housing, then insert
its hooks into the catches as shown. To rewind it, unhook it from the catches and
it will rewind automatically. You
1. Rewind the cover.
2. Hold down the button on the righthand rear quarter panel and lift up the right-hand
cover housing.
3. Remove the cover housing.
SEE MORE:
A: REMOVAL
1) Lift up the vehicle, and then remove the front wheels.
2) Remove the front strut.
Place an alignment mark on the camber adjusting bolt and strut.
Remove the brake hose bracket.
Remove the ABS wheel speed sensor harness.
Remove the two bolts securing the front axle housing t
● Before going down a steep hill, slow down and shift into lower gear (if necessary,
use 1st gear) in order to utilize the overheating of your vehicle’s brakes. Do not
make sudden downshifts.
● When driving uphill in hot weather, the air conditioner may turn off automatically
to
© 2010-2024 Copyright www.suoutback.com