Subaru Outback manuals

Subaru Outback (BR): Scan

The scan mode lets you listen to the first 10 seconds of each track/file in succession.


The scan mode lets you listen to the first 10 seconds of each track/file in succession. Press the “SCAN” button to start scanning upward beginning with the track/ file(s) following the currently selected one. After all track/file(s) in the disk/folder have been scanned, normal playback will be resumed. To cancel the scan mode, press the “SCAN” button again.

NOTE

The scan mode will be cancelled if you perform any of the following steps.

● Press the “RPT” button ● Press the “RDM” button ● Press the “RPT/RDM” button ● Turn the “TUNE/TRACK/CH” dial ● Press the “side of the “FOLDER” button” or “side of the “FOLDER” button
side of the “FOLDER” button ● Press the “● Press the “” or “”” button
● Press the “side of the “SEEK” button” or “side of the “SEEK” button
side of the “SEEK” button ● Press the disc select button ● Select the radio or AUX mode ● Press the “LOAD” button when there is free space in the CD magazine ● Turn off the power of the audio equipment
● Turn the ignition switch to the “LOCK” position

READ NEXT:

 Display selection in CD player

  If you press the “TEXT” button during playback, the indication will change to the next one in the following sequence. For CD-DA:  

 Page (track/folder title) scroll

If you press the “TEXT” button again for at least 0.5 second, the title will be scrolled so you can see all of it. NOTE The display is designed to show titles for up to 30 characters.

 Folder selection

Press the “” side of the “FOLDER” button briefly to select the next folder. Press the “” side of the button briefly to go back to the previous folder. NOTE ● Selecting folde

SEE MORE:

 If the light illuminates constantly

If the light illuminates constantly while driving or does not turn off after the engine starts, an emission control system malfunction has been detected. You should have your vehicle checked by an authorized SUBARU dealer immediately. NOTE This light also illuminates when the fuel filler cap is

 Front Side Marker Light Bulb

A: REMOVAL 1) Disconnect the ground cable from battery. 2) Remove the clips and remove the air intake duct. (When removing the front turn signal light bulb RH) 3) Turn the steering wheel in the opposite direction to the headlight to be removed. Then remove the clips and turn over the mud guard.

© 2010-2024 Copyright www.suoutback.com