Subaru Outback (BR): CD player operation
NOTE
● Make sure to always insert a disc with the label side up. If a disc is inserted with the label side down, the player displays “CHECK DISC”. Refer to “When the following messages are displayed” F5-27.
● If a disc is inserted during a radio broadcast, the disc will interrupt the broadcast.
● After the last track finishes, the disc will automatically return to track 1 (the first track on the disc) and will automatically play back.
● The player is designed to be able to play music CD-Rs and music CD-RWs, but it may not be able to play certain ones.
● CDs (i.e., 8 cm/3 inch CDs) are not supported, and if inserted, they will be immediately ejected.
● Copyright protected WMA/AAC files will not be played by the system. The player will automatically skip to the next file (track).
● Audio data recorded in the MP3/ WMA/AAC formats may not be played depending on the data recording condition.
- How to insert a CD (type A)
- How to insert a CD(s) (type B)
- How to play back a CD
- To select a track from its beginning
- Fast-forwarding and fast-reversing
- Repeating
- Random playback
- Scan
- Display selection in CD player
- Folder selection
- How to eject a CD from the player (type A)
- How to eject CDs from the player (type B)
- When the following messages are displayed
READ NEXT:
How to insert a CD (type A)
While the ignition switch is in the “Acc” or “ON” position, hold a disc with
a finger in the center hole while gripping the edge of the disc, then insert it
in to the slot (with the label
How to insert a CD(s) (type B)
1. Briefly press the “LOAD” button. If the magazine in the player has an idle
position where you can insert a disc, the disc number indicator associated with
the idle position will blink.
I
Inserting a disc in a desired position
1. Briefly press the “LOAD” button. If the magazine in the player has an idle
position where you can insert a disc, the disc number indicator associated with
the idle position will blink.
T
SEE MORE:
Engine low oil level warning light
The engine low oil level warning light illuminates when the ignition switch is
turned to the “ON” position and turns off after approximately 2 seconds.
This light also illuminates when the engine oil level decreases to the lower
limit. The illuminating conditions and remaining oil level a
Rear Differential (VA-type)
A: REMOVAL
The removal procedure for VA-type is included in
"REMOVAL" for T-type. <Ref. to DI-26, REMOVAL,
Rear Differential (T-type).>
B: INSTALLATION
The installation procedure for VA-type is included
in "INSTALLATION" for T-type. <Ref. to DI-28, INSTALLATION,
Rear Differential (T-type).&
