Subaru Outback (BR): Channel scan
If you press the “SCAN” button while the radio is in the category search mode,
the radio turns to the category SCAN mode. In the category SCAN mode, the radio
scans only channels in the selected category. If you press the “SCAN” button while
the radio is not in the category search mode, the radio turns to the ALL SCAN mode.
In the ALL SCAN mode, the radio scans all channels.
In both SCAN modes, the radio will stop at the station for 5 seconds while displaying
the channel number, after which scanning will continue until the entire channel
has been scanned from the low end to the high end.
Press the “SCAN” button again to cancel the SCAN mode and to stop on any displayed
channel.
READ NEXT:
How to preset channels
1. Press the “SAT” button to select SAT1, SAT2 and SAT3 reception.
2. Select the desired channel.
3. Press one of the preset buttons for more than 1.5 seconds to store th
Presetting a channel with a preset button allows you to select that channel in
a single operation. Up to six SAT1, SAT2 and SAT3 channels each may be preset.
SEE MORE:
A: REMOVAL
1) Remove the collector cover.
NOTE:
Follow the steps below when removing the collector
cover.
Pull up the two points at the rear (A).
Pull up the two points at the front (B) while
moving them forward.
2) Remove the battery.
3) Lift up the vehicle.
4) Remove the under cover. <R
1) Seat position forward/backward control switch
To adjust the seat forward or backward, move the control switch forward or backward.
During forward/backward adjustment of the seat, you cannot adjust the seat cushion
angle or seat cushion height.
2) Seat cushion angle control switch
To adju
© 2010-2024 Copyright www.suoutback.com