Subaru Outback (BR): How to preset stations
1. Press the “FM” or “AM” button to select FM1, FM2, FM3 or AM reception. 2.
Press the “” or “”
side of the “SEEK” button or tune the radio manually until the desired station frequency
is displayed. 3. Press one of the preset buttons for more than 1.5 seconds to store
the frequency. If the button is pressed for less than 1.5 seconds, the preceding
selection will remain in memory.
NOTE
● If the connection between the radio and battery is broken for any reason such
as vehicle maintenance or radio removal, all stations stored in the preset buttons
are cleared. If this occurs, it is necessary to reset the preset stations. . If
a cell phone is placed near the radio, it may cause the radio to emit noise when
the phone receives calls. This noise does not indicate a radio malfunction.
READ NEXT:
Presetting a station with a preset button allows you to select that station in
a single operation. Up to six AM, FM1, FM2 and FM3 stations each may be preset.
Using the Auto-store function, you can automatically store 6 stations on the
current waveband by pressing the “A.S” button for more than 2 seconds. Use Autostore
to quickly find the stronges
To receive satellite radio, it is necessary to install the SUBARU genuine satellite
receiver for some models, and to enter into a contract with a satellite radio network
service such as “XMTM sa
SEE MORE:
1. Adjust the seat position:
Driver’s seat: Adjust the seatback to the upright position. Move the seat as
far from the steering wheel as practical while still maintaining full vehicle control.
Front passenger’s seat: Adjust the seatback to the upright position. Move the seat
as far back a
A: PROCEDURE
1. RELEASING OF FUEL PRESSURE
WARNING: Place "NO OPEN FLAMES" signs near the working area.
CAUTION: Be careful not to spill fuel.
1) Remove the fuse of fuel pump from main fuse box.
2) Start the engine and run it until it stalls.
3) After the engine stalls, crank it fo
© 2010-2024 Copyright www.suoutback.com