Subaru Outback (BR): Scan tuning (SCAN)
Subaru Outback (BR) 2010-2015 Owners Manual / Audio / FM/AM radio operation / Tuning / Scan tuning (SCAN)
If you press the “SCAN” button, the radio will switch to the scan mode. In this mode, the radio scans through the radio band until a station is found. The radio will stop at the station for 5 seconds while displaying the frequency, after which scanning will continue until the entire band has been scanned.
Press the “SCAN” button again to cancel the SCAN mode. If you press the “SCAN” button while the radio is stopped at a station, the radio stays stopped at that station. If you press the button while the radio is scanning, the radio stops at the next receivable station.
Automatic tuning may not function properly if the station reception is weakened by distance from the station or proximity to tall buildings and hills.
READ NEXT:
PTY (Program type) group tuning (only FM reception)
Press the “PTY/CAT” button to change to the PTY selection mode. At this time,
the PTY group that you are currently listening to will be displayed for 10 seconds.
In PTY selection mode, “PT
RDS text display
If the PS (Program Service Name) and/or RT (Radio Text) are available, pressing
the “TEXT” button changes the display among PS, RT and frequency. The initial setting
is “PS”.
NOTE
`
Station preset
Preset buttons
SEE MORE:
Wiper operation when snowing
Before driving in cold weather, make sure the wiper blades are not frozen to
the windshield or rear window.
If the wiper blades are frozen to the windshield or rear window, perform the
following procedure.
● To thaw the windshield wiper blades, use the defroster with the airflow selectio
Changing a flat tire
WARNING
● Do not jack up the vehicle on an incline or a loose road surface. The jack
can come out of the jacking point or sink into the ground and this can result in
a serious accident.
● Use only the jack provided with your vehicle. The jack supplied with the vehicle
is designed
© 2010-2024 Copyright www.suoutback.com
