Subaru Outback (BR): Cleaning ventilator grille
Subaru Outback (BR) 2010-2015 Owners Manual / Climate control / Operating tips for heater and air conditioner / Cleaning ventilator grille
Always keep the front ventilator inlet grille free of snow, leaves, or other obstructions to ensure efficient heating and defrosting. Since the condenser is located in front of the radiator, this area should be kept clean because cooling performance is impaired by any accumulation of insects and leaves on the condenser.
READ NEXT:
Efficient cooling after parking in direct sunlight
After parking in direct sunlight, drive with the windows open for a few minutes
to allow outside air to circulate into the heated interior. This results in quicker
cooling by the air conditioner.
Lubrication oil circulation in the refrigerant circuit
Operate the air conditioner compressor at a low engine speed (at idle or low
driving speeds) a few minutes each month during the off-season to circulate its
oil.
Checking air conditioning system before summer season
Check the air conditioner unit for refrigerant leaks, hose conditions, and proper
operation each spring. Have the air conditioning system checked by your SUBARU dealer.
SEE MORE:
Front fog light switch (if equipped)
The front fog lights operate under the following conditions.
● when the light switch is in the “”
position
● when the light switch is in the “AUTO” position and the headlights turn on automatically
However, the front fog lights turn off when the headlights are switched to
Front Grille
A: REMOVAL
1) Remove the front bumper face assembly.
Remove the clips, turn over the front mud guard, and disconnect the fog
light connector. (Model with
fog light)
Remove the clips at the upper side of the bumper.
Remove the clips from the fender.
Remove the clips at the lower side of bu
© 2010-2024 Copyright www.suoutback.com
