Subaru Outback manuals

Subaru Outback (BR): Airflow mode selection button

Subaru Outback (BR) 2010-2015 Owners Manual / Climate control / Automatic climate control system (if equipped) / Automatic climate Control panel / Airflow mode selection button

Select the desired airflow mode by pressing the airflow mode selection button.


Select the desired airflow mode by pressing the airflow mode selection button. The selected airflow mode is shown on the display.

There are four airflow modes that activate the following air outlets.

outlets (Ventilation): Instrument panel
outlets

and foot outlets (Bi-level): Instrument panel outlets
and foot outlets

outlets of the instrument panel and some through windshield defroster outlets (A (Heat): Foot outlets, both side
outlets of the instrument panel and some through windshield defroster outlets (A small amount of air flows to the windshield and both side windows to prevent fogging.)

outlets, foot outlets and both side outlets of the instrument panel (Heat-def): Windshield defroster
outlets, foot outlets and both side outlets of the instrument panel

NOTE

When the “air conditioner compressor automatically operates to quickly defog the windshield” mode is selected, the
air conditioner compressor automatically operates to quickly defog the windshield and the air inlet selection is automatically set to the “outside air” mode.

READ NEXT:

 Air inlet selection button (Automatic climate control system)

  Select airflow by pressing the air inlet selection button “”.   ON position (recirculation): Interior air is recirculated inside the vehicle. Press the air inlet selectio

 Temperature sensors

1) Solar sensor 2) Interior air temperature sensor The automatic climate control system employs several sensors. These sensors are delicate. If they are treated incorrectly and become damaged, t

 Operating tips for heater and air conditioner

SEE MORE:

 Continuously Variable Transmission - List of Diagnostic Trouble Code (DTC)

A: LIST Diagnostic Procedure with Diagnostic Trouble Code (DTC) A: DTC P0705 TRANSMISSION RANGE SENSOR CIRCUIT (PRNDL INPUT) DTC DETECTING CONDITION: Inhibitor switch is faulty. At least 2 range signal is input. TROUBLE SYMPTOM: Shift characteristics are erroneous.

 DTC P2096, P2097, P2101, P2102, P2103, P2109, P2122, P2123, P2127, P2128, P2135, P2138, P2227, P2228, P2229, P2610

DU:DTC P2096 POST CATALYST FUEL TRIM SYSTEM TOO LEAN (BANK 1) 1. OUTLINE OF DIAGNOSIS Detect the malfunction of fuel system from the size of the sub feedback learning value. Control the sub feedback learning and judge as NG when the learning value is in the lean zone. 2. COMPONENT DESCRIPTION

© 2010-2024 Copyright www.suoutback.com