Subaru Outback (BR): A/C – Air conditioner button
If the windshield starts to fog when the climate control system is operated in
the AUTO mode, press the air conditioner button “A/C” to defog and dehumidify. When
this button is pressed, the air conditioner compressor turns on and the indicator
light “A/C” on the display illuminates.
To turn off the air conditioner compressor, press the “A/C” button again.
NOTE
The air conditioner compressor does not operate when the outside air temperature
is below 328F (08C).
READ NEXT:
Select the desired airflow mode by pressing the airflow mode selection button.
The selected airflow mode is shown on the display.
There are four airflow modes that activate the following air outl
Select airflow by pressing the air inlet selection button “”.
ON position (recirculation): Interior air is recirculated inside the vehicle. Press the air inlet selectio
1) Solar sensor
2) Interior air temperature sensor
The automatic climate control system employs several sensors. These sensors are
delicate. If they are treated incorrectly and become damaged, t
SEE MORE:
BJ:DTC P0327 KNOCK SENSOR 1 CIRCUIT LOW (BANK 1 OR SINGLE SENSOR)
1. OUTLINE OF DIAGNOSIS
Detect the open or short circuit of knock sensor.
Judge as NG if out of specification.
2. COMPONENT DESCRIPTION
To knock sensor harness
Case
Weight
Piezoelectric element
Nut
Resistance
3. ENABLE CON
A: PROCEDURE
CAUTION: Remove foreign matter (dust, water, oil etc.) from the VDCCM&H/U connector during removal and installation.
NOTE:
To check the harness for open or short circuits, shake problem spot or connector.
Refer to "Check List for Interview". <Ref. to VD
© 2010-2024 Copyright www.suoutback.com