Subaru Outback manuals

Subaru Outback: Temperature control button

Driver’s side


Driver’s side

Passenger’s side


Passenger’s side

To increase the temperature setting, press the “side of the temperature control button. To decrease the temperature setting, press
side of the temperature control button. To decrease the temperature setting, press the “button.” side of the temperature control
button.

Each temperature setting is shown on the display. When the “LO” is shown, the system provides maximum cooling performance. When the “HI” is shown, the system provides maximum heating performance.

DUAL mode

It is possible to make separate temperature settings for the driver’s side and


It is possible to make separate temperature settings for the driver’s side and passenger’s side (DUAL mode).

To activate the DUAL mode: Press the “DUAL” button. When the DUAL mode is activated, the indicator light on the “DUAL” button illuminates.

To deactivate the DUAL mode:

Press the “DUAL” button again. When the DUAL mode is deactivated, the indicator light on the “DUAL” button turns off and the temperature setting for the front passenger’s side becomes the same as the setting for the driver’s side.

READ NEXT:

 Defroster button

To defrost or dehumidify the windshield and front door windows, press the defroster button “”. When the “” button is pressed, the air conditioner compressor automatically operates to

 Fan speed control button

The fan speed control button has 6 different fan speed positions. The fan speed is shown by the display.

 A/C – Air conditioner button

If the windshield starts to fog when the climate control system is operated in the AUTO mode, press the air conditioner button “A/C” to defog and dehumidify. When this button is pressed, the

SEE MORE:

 Expansion Valve

A: REMOVAL 1) Disconnect the ground cable from battery. 2) Using the refrigerant recovery system, discharge refrigerant. <Ref. to AC-24, PROCEDURE, Refrigerant Recovery Procedure.> 3) Remove the connector and bolts, and remove the high-pressure hose and AC pipe from the expansion valve. 4

 Spot Map Light

A: REMOVAL NOTE: The spot map light is a single unit with the overhead console. 1) Disconnect the ground cable from battery. 2) Remove the overhead console assembly. Push and open the rear end of the overhead console lid, and remove the screws. Remove the clips and pull out the overhead consol

© 2010-2024 Copyright www.suoutback.com