Subaru Outback (BR): Compass calibration
1. If a “C” is displayed in the compass window, the compass needs to be calibrated.
2. Drive the vehicle in a circle at 5 mph (8 km/h) or less until the display reads
a direction.
3. You can also calibrate the compass by driving your vehicle on your everyday routine.
The compass will be calibrated once it has tracked a complete circle.
4. To recalibrate your compass, push and hold the switch for 9 seconds until a “C”
appears in the compass window.
5. Calibrate the compass according to step 2 or step 3.
READ NEXT:
1) HomeLink® button 1
2) HomeLink® button 2
3) LED
4) HomeLink® button 3
5) Sensor
6) Automatic dimming on/off button
7) Compass display button
8) Compass display
The auto-dimming mirror
The mirror has a photosensor attached on both the front and back sides. During
nighttime driving, these sensors detect distracting glare from vehicle headlights
behind you and automatically dim
Compass calibration zones
1. Refer to the “Compass calibration zones” map shown above to verify that the
compass zone setting is correct for your geographical location.
2. Press and hold the
SEE MORE:
A: COMPONENT
1. FRONT SEAT BELT
Adjustable anchor ASSY
Outer belt ASSY
Seat belt retractor ASSY (Outer belt ASSY)
Center pillar trim UPR
Inner belt ASSY
Tightening torque: N*m (kgf-m, ft-lb)
T1: 7.5 (0.76, 5.5)
T2: 30 (3.06, 22.1)
T3: 38 (3.87, 28.0)
T4: 53 (5.4
A: REMOVAL
1. SEDAN MODEL
1) Remove the rear seat cushion assembly.
Pull up the seat cushion and release the hook.
CAUTION:
If the hook is disconnected from the vehicle body, replace the hook with the new
part to prevent the
decline of the fixed force of the seat.
Remove the hook (A) by push
© 2010-2024 Copyright www.suoutback.com