Subaru Outback (BR): Auto-dimming mirror with compass (if equipped)
1) LED
2) Switch
3) Sensor
4) Compass display
The auto-dimming mirror has an anti-glare feature which automatically reduces
glare coming from headlights of vehicles behind you. It also contains a built-in
compass.
● By pressing and holding the switch for less than 3 seconds, the automatic dimming
function is toggled on or off. When the automatic dimming function is on, the LED
indicator will illuminate. Even with the mirror in anti-glare mode, the mirror surface
turns bright if the transmission is shifted into reverse. This is to ensure good
reward visibility during reversing.
● By pressing and releasing the switch for 3 seconds, the compass display is
toggled on or off. When the compass is on, an illuminated compass reading will appear
in the upper right corner of the mirror.
When cleaning the mirror, use a paper towel or similar material dampened with
glass cleaner. Do not spray glass cleaner directly on the mirror as that may cause
the liquid cleaner to enter the mirror housing and damage the mirror.
READ NEXT:
The Subaru Outback (BR) features a mirror equipped with photosensors on both its front and rear sides. These sensors are designed to detect bright glare from headlights of vehicles behind you during
Calibration Zones for Compass
1. Check the "Compass calibration zones" map displayed above to ensure that the compass zone setting matches your geographic area accurately.
2. Hold down t
1. If a “C” is displayed in the compass window, the compass needs to be calibrated.
2. Drive the vehicle in a circle at 5 mph (8 km/h) or less until the display reads
a direction.
3. You can a
SEE MORE:
Legacy
NOTE
It may be difficult to replace the bulbs. We recommend that you have the bulbs
replaced by your SUBARU dealer if necessary.
1. Turn the knobs of the cover 90 degrees counterclockwise to remove the cover.
1) Brake/tail and rear side marker light
2) Rear turn signal light
3) Ba
This setting allows you to direct air of different temperatures from the instrument
panel and foot outlets. The air from the foot outlets is slightly warmer than from
the instrument panel outlets.
1. Set the air inlet selection button to the OFF position.
2. Press the “” button.
3. Set th
© 2010-2024 Copyright www.suoutback.com